Name:
Country:
E-mail:
Tel:
Project:
Time:
IP:
Message:
NewsHome > News >

Daily maintenance and maintenance of cable wire recycling machine

Time:2021-05-06 16:18 Author:Suny Group

The cable wire recycling machine equipment may also have many unpredictable problems during the work process. This requires us to carry out special repair and maintenance of the cable wire recycling machine equipment. It is very necessary to master a certain maintenance strategy.

Cable Wire Recycling Machine

Equipment maintenance and maintenance:

1. The bearings of all moving parts of the Tongmi machine have been greased before leaving the factory, but only for debugging equipment. After the completion of the debugging work, the bearings of all moving parts should be refilled with grease. Each operating part is filled with new grease every 40 hours of operation, and the crusher bearing is filled with new grease every 8 hours of operation.

2. The cutting tool will become blunt after a period of production, and it will affect the crushing effect and the sorting effect when it becomes blunt, so it needs to be polished every once in a while. When polishing the knives, you should choose mechanical polishing, and don't polish them at will. The cutter will become narrower after being polished many times. When the gap between the rotating blade and the fixed blade of the casing cannot meet the crushing requirements, the old cutter needs to be replaced. Turn off the power when grinding or changing tools. The gap between the movable knife and the fixed knife should be adjusted every time after grinding or changing the knife.

Matters needing attention in the production of cable wire recycling machine:

1. During the production of the cable wire recycling machine, the raw materials should be classified and broken, and the copper wire and aluminum wire should not be mixed.

2. The wire diameter of each batch of crushed raw materials should be the same. The mixing of thick and thin wires will affect the sorting effect.

3. The cable wire recycling machine equipment is only used for crushing copper wire and aluminum wire, and shall not be used for crushing other materials

4. Turn on a single machine first after power-on, pay attention to observe whether the rotation of the motor is consistent with the rotation of the mark, if there is an inconsistency, cut off the power and adjust the wiring sequence in time.

5. When the equipment is started online, it should be empty for 20-30 minutes. Pay attention to the operation of each machine and observe whether the belt of the feeding conveyor is off-track. If there is off-line, make timely adjustments and wait until all machines are running properly. Feeding and debugging.

For the staff who want to operate the cable wire recycling machine, professional training is required. When using it, read the operating instructions carefully, and try to let professional technicians guide the operation. Only the operator is familiar with the structure and performance of the cable wire recycling machine and its components. The name, specification and function of the cable wire recycling machine can reduce the wear and tear of the operation during use, which is more conducive to the use and production of the cable wire recycling machine and increase the service life of the cable wire recycling machine.

Tags:

 

CONTACT US:

If you have any requirement or suggestion, please fill in the form and send to us, or contact us by E-mail:sunymachine@gmail.com,thanks!

Name:
Country:
E-mail:
TEL:
Project:
Time:
Message: