How to debug the mask machine?
There are three major problems in the production of flat mask machines: one is insufficient recycling rate and difficulty in recruiting personnel; second, the production of mask equipment is unstable, and there will be a lot of problems after the equipment runs for a period of time, the speed is slow, and sometimes it cannot be started; third, it is in production There are still many difficulties in terms of qualifications, guarantees, and raw material procurement.
There are many reasons for the stability of the equipment: one is the problem of the equipment itself, design defects, component quality problems, etc.; the other is the problem of raw materials, and the quality of meltblown cloth is uneven, which is also a major factor affecting production.
The width and thickness of meltblown fabrics and non-woven fabrics will directly affect the normal use of mechanical equipment. In the actual production process, the width and thickness of the cloth may exceed the forming range of the machine in the plastic processing process, and many problems will be encountered in the production process of the nose bridge band. Encounter problems in debugging, will
A lot of time, energy and materials will be lost in the debugging process, which is very terrible.
If the material band is not well formed, it may cause the mask to not fold smoothly, the nose clip line is stacked, the compression welding of the body does not fit, or the welding effect of the sealing edge is not perfect, which is also a common phenomenon in the production of masks.
The width, thickness and flexibility of the nose bridge will affect the debugging of the flat face mask machine. If the nose bridge is not good, the packaging will not be smooth; in addition, if the nose bridge is too thick, it will not only break the blade, but also cause the cutting to be uncontinuous, or the cutting angle is not good, resulting in the accumulation or dislocation of the nose bridge. Our machine requires that the bridge of the nose bridge must be centered in the middle.
The elasticity, thickness and flat belt of the ear strap tension greatly interfere with the good speed in the actual production process. For experienced automation engineers, adjusting the earband welding machine is not difficult. If you understand it, you will know the actual structure of the action. In fact, in actual production, there will also be various small problems, such as inability to open the wire, cutting the wire, welding failure, offset welding, unqualified penetration, etc., resulting in the production of a large number of defective products. At this time, it is necessary to deal with many Commissioning and maintenance are carried out. Whether it is a linear drawstring, a reciprocating drawstring or a rotary drawstring, each has its own characteristics. In terms of efficiency, the draw belt is higher than the rotating belt.
Debugging experts rely on perseverance to debug the flat mask machine in a short period of time, because this is not a short-term job.
Recommend products
CONTACT US:
If you have any requirement or suggestion, please fill in the form and send to us, thanks!E-mail:sunymachine@gmail.com | Whatsapp:+8613674945231
