Wire stripping machine waste wire recycling equipment for copper
The wire stripping machine has a wide range of applications and a long service life. It can open all kinds of cables, high-voltage cables, optical cables and wires. The rolling wheel can press monofilaments above 1.5mm, sheathed flat wires, steel wires, etc.
Operating instructions for wire stripping machine:
1 Start the motor of the cable stripping machine to check whether it is running normally. When feeding, check the diameter of the outer rubber-plastic cable of each file, and feed the material one by one.
2 In order to make the blade of the cable stripping machine durable, the connector of the rubber and plastic cable should be cut off when feeding, so as to avoid the blade notch chipping.
3 If the material is too deep or broken after the feed, pay attention to the following points: the feed file should be adjusted, that is, the tightness of the M12 screw pressure on both sides of the blade shaft; check whether the position is misplaced when feeding; whether the blade is newly replaced , Whether the cutting edge is too sharp, use special oilstone to trim it slightly until it is moderate.
4 If the rubber and plastic have been peeled after the feed is out, but the copper wire cannot be spit out. There are mainly 4 situations where the upper shaft knurling is too deep. The upper shaft should be ground with a special oil stone, but it cannot be ground too much. Too much grinding will easily cause the oily cable to be difficult to drive; whether the spring pressure is too loose, should Tighten the pressure to stop spitting; if the wire diameter is too small, or the gap between the upper and lower shafts is too large, the gap between the two shafts should be adjusted to 0.4-0.6mm; the processed rubber-plastic cable has already heated up, and the copper wire cannot be spit out.
5 After the cable stripping machine feeds the material, if the compound pressure gear cannot drive the cable over, and the material stays in the middle, the following situations will occur: check whether the belts in each gear are slack; check whether the spring pressure on both sides of the pressure gear is excessive If there is no top force, the pressure should be relaxed; the cable is too oily, causing the two shafts to slip, and the two shafts should be wiped dry frequently (when drying, if the machine is running, please pay attention to safety).
Common problems of wire stripping machine: If the outer skin has been stripped after feeding, but the copper wire cannot be exposed. The main situations are as follows:
1. The upper shaft is knurled too deep. Use a sharpening stone to grind the upper shaft, but not excessively. Excessive grinding will easily cause oily cables to be difficult to drive;
2. Whether the spring pressure is too loose, the pressure should be tightened;
3. The wire diameter is too small, or the gap between the upper and lower shafts is too large, adjust the gap between the two shafts appropriately;
4. The processed cable has been heated, and the copper wire will not be easily exposed to the outer skin.
5. After the cable stripping machine feeds the material, the rolling gear cannot drive the cable, and the material stays in the middle. The following situations will occur:
1. Check whether the belts of each gear are slack;
2. Check whether the spring pressure on both sides of each gear is too tight, there is no top force, and the pressure should be relaxed;
3.The cable is too oily, causing the two shafts to slip, and the two shafts should be cleaned frequently.
Recommend products
CONTACT US:
If you have any requirement or suggestion, please fill in the form and send to us, thanks!E-mail:sunymachine@gmail.com | Whatsapp:+8613674945231
