Precautions for the use of four-side sealing wet tissue packaging machine

The four-side sealing wet tissue packaging machine can produce all kinds of dry towels and folded square hot and cold wet wipes at will in a short time, which is convenient and quick to use, clean and hygienic. It aims to adapt to people's lives, match modern people's pursuit of fashion, improve the traditional habit of using towels, and better protect consumers' health. The four-side sealing wet tissue packaging machine can produce folded hot and cold wet wipes immediately under the automatic control of microcomputer according to user needs, and can also quickly realize the conversion of cold wet wipes, hot wet wipes, and dry wet wipes.

In the process of rapid development of the machinery industry, some mechanical failures will inevitably occur. Common faults and maintenance methods of the four-side sealing wet tissue packaging machine:

1. If the speed of the four-side sealing wet tissue packaging machine is too fast, the heat-sealability of the inner layer of the coating will be poor. If the temperature is too low, the seal will leak or become unstable. The maintenance method is to slow down, heat up, and change the film material.

2. The solid-state circuit breaker of the four-side seal wet tissue packaging machine is burned out, the temperature control instrument is damaged, the thermocouple is damaged, and the thermometer cannot control the temperature. The maintenance method is to replace the coupling, temperature control instrument and heating element.

3. The film color code is too light, the film drive is slippery, the color code tracking cannot be opened, and the cutting position will deviate from the color code. The maintenance method at this time is to refer to the packaging machine manual and adjust its sensitivity. In the man-machine dialogue interface, switch the tracking mode to "tracking switch".

4. The knife holder is too high or too low, and the packaging speed is too fast. When the push rod and the tool are not synchronized, the tool will cut on the product. The maintenance method is to reduce the packaging speed and adjust the height of the end sealing parts so that the center of the sealing knife is in the middle of the height of the product.

5. When the temperature of the four-side sealing wet tissue packaging machine is too high, the speed is too slow, and the outer layer of the envelope has poor heat resistance, there will be burnt marks at the seal. The maintenance method is to speed up, cool down, and replace the membrane material.

6. When the air pressure is not right, the cylinder swing rod becomes loose, the heating temperature is low, the hot pressing roller and the driving roller are not parallel, and the heat sealing is not good. The maintenance method is to adjust the parallelism, adjust the temperature and air pressure to make them parallel.

Recommend products

>>More

Solar Panel Recycling Plant

Lithium Battery recycling plant

Copper Electrolysis Machine

E Waste Recycling Plant

Large Cable Wire Recycling Machine

Lead Smelting Cupola Furnace