Mask machine body machine filming machine debugging

Fully Automatic Mask Making Machine 1+1

The feeding rack is unstable, and the material roll is shifted left and right

Answer: First of all, it must be fixed, and secondly, the roll holder must be level. Tighten the tensioner, or increase the load.

Uneven feeding gantry of mask cloth

Answer: Adjust the bracket to be parallel

Mask pleated size

Answer: The pre-squeezing and crimping parts should be level, and the interval of the mechanism should be the same.

The bridge of the nose spreads out when installed

Answer: The wire coil must be compressed first, the installation is complete, and then the strapping tape must be cut.

Blocked nose and mouth

Answer: a. The bridge of the nose is too hard or too soft

b. The line in the bridge of the nose and the mouth is stuck, or the line is slippery

c. The exit position is inside or outside

d. The cloth roll goes wrong

Nose bridge folds

Answer: a. The cloth roll is biased

b. The position of the small baffle before welding is wrong

c. L pressure plate is too loose or too tight or too oblique

Wrinkles after compression

Answer: a. The cloth roll is biased

b. The position of the small baffle is wrong before welding,

c. L pressure plate is too loose or too tight or too oblique

Mask deformed

Answer: The shaping press roller is too tight and creases before welding

The mask piece cannot be cut off

Answer: The cutter position is too high, or the cutter is worn

Final press wheel adjustment of the main body machine

Answer: Pressing too loosely or too tightly will cause the material to float or deform the mask. Adjust the compression to the level and fly out.